Technical note: A low-cost, automatic soil–plant–atmosphere enclosure system to investigate CO 2 and evapotranspiration flux dynamics

Abstract

Investigating greenhouse gases (GHGs) and water flux dynamics within the soil–plant–atmosphere interphase is key for understanding ecosystem functioning, as they reflect the ecosystem's responses to environmental changes. Understanding these responses is essential for developing sustainable agricultural systems that can help to adapt to global challenges such as increased drought. Typically, an initial understanding of GHGs and water flux dynamics is gained through laboratory or greenhouse pot experiments, where gas exchange is often measured using commercially available manual closed-chamber (leaf) systems. However, these systems are rather expensive and often labor-intensive, thus limiting the number of different treatments and their repetitions that can be studied. Here, we present a fully automatic, low-cost (EUR 2 and evapotranspiration (ET) fluxes. It can operate in two modes: an independent and a dependent measurement mode. The independent measurement mode utilizes low-cost NDIR (non-dispersive infrared) CO 2 (K30 FR) and relative humidity (SHT31) sensors, thus making each greenhouse coffin a fully independent measurement device. The dependent measurement mode connects multiple greenhouse coffins via a low-cost multiplexer (EUR 2 O, CH 4 and stable isotopes). In both modes, CO 2 and ET fluxes are determined through the respective concentration increase during closure time. We tested both modes and demonstrated that the presented system is able to deliver precise and accurate CO 2 and ET flux measurements using low-cost sensors, with an emphasis on calibrating the sensors to improve measurement precision. By connecting multiple greenhouse coffins via our low-cost multiplexer to a single infrared gas analyzer in the dependent mode, we could additionally show that the system can efficiently measure CO 2 and ET fluxes in a high temporal resolution across various treatments with both labor and cost efficiency. Therefore, the developed system is expected to be a valuable tool for conducting greenhouse experiments, enabling comprehensive testing of plant–soil dynamic responses to various treatments and conditions.

Code and data availability

The paper's CO2/ET flux measurements and Arduino analysis/control code are publicly deposited on Bonares (ZALF), explicitly stated in the Code and data availability section and the reference list.